AutoCAD 2011 - Pickadd has changed

The system variable PICKADD has been changed for 2011. Most people probably will not notice, but I like it. Previously, there were 2 choices for this variable, 0 and 1. A setting of 2 was added. See the summary below.

  • 0 - means that only your last selection is valid. In other words, if you select a entity, then select another entity, the first one becomes unselected.
  • 1 - is what most people use. This allows you to continue to add entities to a selection set.
  • 2 - works just like 1, expect that when using the ._Select command, the entities remain selected when the command is over. Previously when you used the ._Select command then executed a command, you had to use _P to refer to the previous selection set. Now you can use the ._Select command, create a selection and then launch the desired command with the selected objects pre-selected.

For more details, see: PICKADD - AutoCAD 2011 Documentation



 


All content is copyright © CAD PANACEA 2005-2013 unless otherwise noted and may not be reproduced. All comments posted to this blog are the sole responsibility of the person making the comment.

Google, as a third party vendor, uses cookies to serve ads on this site. Google's use of their cookies enables it to serve ads to users based on their visit to your sites and other sites on the Internet. You may opt out of the use of these cookies by visiting the Google ad and content network privacy policy.

Powered by Drupal