DWG TrueView 2013 Install Help

If you are about to install DWG Trueview 2013, or you are in the process of doing so and are running into problems, read on.

Jimmy over at JTB World has some good information on this subject. Note that Trueview 2013 requires Microsoft .NET 4.0 (SP1). Unfortunately, the DWG Trueview installer offers no assistance as to where to find this.

So back to JTB World. Jimmy points out that not only do you need .NET 4.0, you will need the "Full" version, not just the "client" version. On the Microsoft download page, the "Full" version is listed under "For Server and Development". Of course, be sure to download the correct x64 or x86 version as needed.

You will also need to install the update KB2468871 (which Autodesk calls SP1 in the error message you receive if you try to install without it). The update can be found here.

After you get these components installed correctly, then you can proceed with the DWG Trueview 2013 installation.

Tags: 
DWG Trueview
2013 Products
Install
.NET
DOTNET
Submitted by rkmcswain on Mon, 06/25/2012 - 08:17

 

All content is copyright © CAD PANACEA 2005-2013 unless otherwise noted and may not be reproduced.
All comments posted to this blog are the sole responsibility of the person making the comment.

 

Google, as a third party vendor, uses cookies to serve ads on this site.

Google's use of their cookies enables it to serve ads to users based on their visit to your sites and other sites on the Internet.

You may opt out of the use of these cookies by visiting the Google ad and content network privacy policy.

Powered by Drupal